Internal Jumper; Dip Switch; Table 11-11 Internal Jumper Used By The 16Multi Card; Table 11-12 Configurations Of The Dip Switch On The 16Multi Card - Raisecom RC3000-15 Hardware Description

Raisecom
RC3000-15 (P100R001) Hardware Description
IN-USE (13–16) Green

11.1.6 Internal jumper

The jumper JP1 is used to configure downloading mode of MCU program. Enter ISP mode. In
this mode, the RC3000-15 is waiting to be upgraded. You can upgrade MCU program through
the serial interface on the backplane.
Table 11-11 lists the internal jumper used by the 16MULTI card.

Table 11-11 Internal jumper used by the 16MULTI card

Short-circuited
Disconnected
After upgrade, JP1 must be disconnected; otherwise, the 16MULTI card will
malfunction.

11.1.7 DIP switch

You can configure the default value of the 16 MULTI card through the DIP switch. After you
configure the 16MULTI card through software, the DIP switch will not take effect.
Table 11-12 lists configurations of the DIP switch on the 16MULTI card.

Table 11-12 Configurations of the DIP switch on the 16MULTI card

Configuring
voice
interfaces
Configuring
E&M
LED Color
JP1
CONN ISP ON
NARMAL
BIT
– No. Function description
Configure polarity
reverse on the FXS
1 interface (configuring
through software is
invalid).
Configure audio 2/4
2
wire mode
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Data channel in-use LED
 Blinking green: data is being received or sent. The
blinking frequency is related to the volume of data being
received.
Function
Description
Supported
2-wire mode
11 Multi-service card
Description
Description
Enter ISP mode.
Enter normal working mode.
ON OFF (default)
Not supported
4-wire mode
172