Chapter 4 Device Settings; Dip Switch Description; The Location Of The Dip Switches - Raisecom RC832-30 User Manual

www.raisecom.com

4.1 DIP switch description

4.1.1 The location of the DIP switches

There are an 8-bit DIP switch SW1 and a 4-bit DIP switch SW2 on the back of the print circuit
board.
4.1.2 DIP switch description
DIP switch SW1

Chapter 4 Device Settings

Bit 1~3: Reserved
Bit 4: ALS function setting
Bit 4 ALS function setting
OFF Disable
ON Enable
Bit 5: E1 loopback setting
Bit 5 E1 loopback setting
OFF No loopback
ON Loopback
Bit 6: Reserved
Bit 7: Loopback type setting
Users can set the loopback of E1 to "remote bidirectional loopback" or "local bidirectional
loopback" when the loopback of the E1 is enabled.
Bit 7 Loopback type selection
OFF Remote bidirectional loopback
ON Local bidirectional loopback
The following two figures show the loopback point of the remote bidirectional loopback and
local bidirectional loopback respectively.
User Manual
7