Configuring Profisafe Via Profinet - Siemens SINAMICS S120 Function Manual

Commissioning
7.5 PROFIsafe via PROFINET
7.5.3

Configuring PROFIsafe via PROFINET

Configuring PROFIsafe communication using SINAMICS S120 as an example
Configuring PROFIsafe via PROFINET is almost identical to configuring "PROFIsafe via
PROFIBUS".
The difference is that the SINAMICS drive unit and SIMATIC F-CPU are in the same
PROFINET subnet instead of in the same PROFIBUS subnet.
1. In HW Config, create a PROFINET-capable F-CPU, e.g. CPU 317F-2 PN/DP,
2. In the standard module catalog, under PROFINET IO, choose the module that you want
3. Drag the module to the line of the PROFINET IO subnet. The IO device is inserted.
4. Save and compile the settings in HW Config, and then load them to the target device.
This sets up a PROFINET connection between the F-CPU and the SINAMICS S120 drive.
158
corresponding to the hardware that has been installed. Create a PROFINET subnet and
configure the F-CPU as an IO controller. Information about configuring an IO controller of
F-CPU 317F-2 can be found in this reference: SIMATIC PROFINET IO Getting Started:
Collection.
to connect to the PROFINET IO subnet as an IO device, e.g. a CU320-2.
The Properties -> Ethernet Interface SINAMICS-S120-2 window opens. A suggested IP
address will already be displayed here and the subnet selected. Confirm with "OK" to
accept the setting.
Function Manual, (FHS), 11/2009, 6SL3097-4AR00-0BP0
Safety Integrated