User Termination/Pri; Figure 9-5. User Term Pri / Ifce Config Menu Tree - ADTRAN ATLAS 800 User Manual

User Termination/PRI

IfceConfig
»» Switch Type
»» First DS0
»» Number of DS0s
61200180L1-1
• Default value = 0. The default ID for all end points is 0 and for all
Accept # s is 0. With default values, all calls are routed based only on
the dialed number.
• Multiple end points can have the same Source ID .
• When creating the call accept list, specify a Source ID as well as a dialed
number or range of dialed numbers to accept.
Say, for example, that an application requires all calls originating from
Port 1 of the T1/PRI module in Slot 1 be switched to Port 4 of that same mod-
ule. You would assign a unique Source ID (e.g., 7) to Port 1 of the module,
and then configure Port 4 to only accept calls from that unique Source ID (7).
Figure 9-5 shows the available interface configuration options when you are
working in User Term , Slot is defined as a T1/PRI module, and Sig is set to
PRI .
Lucent 5E
Switch Type AT&T 4ESS
First DS0
Number of DS0s
Strip MSD
Netwrk Spec. Fac.- Voice
Netwrk Spec. Fac.- Data
Called Digits Transferred
Outgoing Caller ID
Source ID
Swap ANI/DNIS

Figure 9-5. User Term PRI / Ifce Config Menu Tree

Write security: 3; Read security: 5
Defines the type of PRI switch that ATLAS will emulate. If connected to
another ATLAS, both need to be set to the same switch type ( Lucent 5E or
AT&T 4ESS ).
Defines the first active DS0 for a fractional PRI.
Write security: 3; Read security: 5
Defines the number of DS0s used for calls on a fractional PRI. DS0 24 is
assumed to be used by the PRI for the D channel.
ATLAS 800 User Manual
Chapter 9. Dial Plan Terminal Menu
None
Three
Four
All
Send as Provided
Substitute if not present
Substitute Always
ID Presentation
ID Number
ID Presentation
ID Number
9-15