10 Servicing
10.1.7 Removal of the printed circuit board (PCB)
Nº
1
Power supply PCB
2
Control PCB
Remove the air inlet grille as indicated in chapter
air inlet
grille, see on page 268.
Remove the electrical box cover as indicated in chapter
of the electrical box
cover, see on page 269.
Separate all of the wiring connectors on the printed circuit boards
(PCB).
Remove the PCB by pressing carefully on the support tabs with
long-tipped pliers, as shown in the figure.
C A U T I O N
•
Do not touch the electrical components of the PCB.
•
Do not apply force to the PCB, as this could damage it.
•
Pay special attention to the position of the connectors on
the PCB. An incorrect position during installation may
damage the PCB.
272
SMGB0063 rev. 1 - 10/2010
Part
Removal of the
Removal