Removal Of The Heat Exchanger - Hitachi RCI Service Manual

10 Servicing
Nº
The hook is released by turning this part in the direction
1
of the arrow
2 Front spacers
Nº
1 Two rear spacers
Attach the three front spacers and secure the main PCB.
Insert the PCB connectors following the removal procedure in
reverse order. Fit the terminal board fixture plate, the terminal
board fixtures, the electrical box fixtures and covers and the
terminal board cover.
C A U T I O N
Be careful not to catch any wire between the components or
with incorrect or barely visible connections.

10.8.9 Removal of the heat exchanger

Remove the front panel as indicated in Section
panel, see on page 323.
N O T E
Remove the right-hand cover instead of the front panel on
RPK-(2.5-4.0)FSN2M models.
Remove the electrical box as indicated in section
electrical box panel, see on page 329.
Remove the drain pan as indicated in section
pan, see on page 340.
Remove the fixture from the piping at the rear of the heat exchanger.
337
SMGB0063 rev. 1 - 10/2010
Part
Part
Removal of the front
Remove the
Removal of the drain
10