Hitachi RCI Service Manual page 345

10 Servicing
Nº
1 Spacer
Remove the 5 spacers and the control PCB
Unlock the spacer and lift the power supply PCB
N O T E
The spacer does not have to be fully removed.
Nº
1 Side cover lock
2 Side cover
3 Side cover lock
Release the three locks on the side cover and remove the electrical
box.
N O T E
Use a screwdriver for easier removal.
Nº
1 Power supply printed circuit board
2 Release sheet
Remove the power supply PCB and disconnect the electrical box.
After replacing the power supply PCB, re-insert it following the
removal procedure in reverse order.
When the heat release sheet is released on inserting the PCB, fit
the end of the areas covered in silicone and the end of the sheet.
333
SMGB0063 rev. 1 - 10/2010
Part
Part
Part
10