Hitachi RCI Service Manual page 229

6 Optional functions
An example is shown in the following figure:
Fd – Upper heating temperature setting limit
This function is used to define an upper temperature setting limit for the HEAT function. This function enables the heating
range to be reduced for configuration using the remote control. The setting condition is shown below.
Setting
00
01
02
03-08
09
10
An example is shown in the following figure:
FE – Not used
Setting
00
01
02
FF – ON/OFF timer function interlock
This function is used to lock timer activation.
Setting condition
00
01
H1 – Maintenance alarms
This function is used to display or hide maintenance alarms.
Setting condition
00
01
217
SMGB0063 rev. 1 - 10/2010
Contents
Standard
Lower limit -1 °C
Lower limit -2 °C
Lower limit -(03-08) °C
Lower limit -9 °C
Lower limit -10 °C
Contents
Not available
Used as setting for conditions 00
Contents
Not available
Available (factory setting)
Contents
Display
Hide
6