Table of Contents
Advertisement
3.2.13 Network
LAN
For connecting the A
RGUS
onboard LAN adapter avai
vailable:
•
Onboard LAN Adapter 10/100 Mbps
optional, depending on the model of A
•
Ethernet Card 10/100 Mbps, PCI
•
Ethernet Card 10/100/1000 Mbps, PCI
For a redundant connection to the LAN both cards are also available as server adapters, allowing to configure
them in teaming mode, sharing one single IP-address. You can see whether a network card is of server or des
top type on the label on the card. Please refer also to section
tion.
The onboard LAN adapter, the 10/100 Mbps and the 10/100/1000 Mbps network card offer each a Twisted Pair
connection:
Order
The network card is inserted in the PCI slot of the processor with the lowest number. If several network cards are
used they are inserted consecutively.
Inserting a network card in an Argus OmniBus in not supported!
Barco – Argus Workstation for Windows – DOC-3266-2 – Revision 06 – April 2004
P
to the LAN (local area network) there are two different network cards or an
ROCESSOR
P
RGUS
ROCESSOR
DATA
ACT/LNK
100 TX
100 Mbps onboard LAN adapter (left), 100 Mbps Ethernet Card (middle) and 1000 Mbps Ethernet Card (right)
. See section
3.1.1 Argus Processor
You can see whether a network card is of server or desk-
6.2.10 Redundant network adapter
DATA
ACT/LNK
10=OFF
100=GRN
1000=YLW
_________________________________________________________________________
3. Getting started
for more informa-
Figure 3-27
Connecting to Twisted Pair (RJ
(RJ-45)
Figure 3-28
Network card in the A
P
RGUS
ROCESSOR
3-22
Advertisement
Table of Contents
