•
Insert the power module into the system. Take care to insert it in the same orientation like the other module
with the mains connection [25] on the upper side!
•
Tighten the securing screw!
•
Switch on the power module with the power switch [35]!
•
Check that the green LED [36] lightens up!
•
Check that the red LED power module failed [6] at the front of the P
5.1.2 RAID
An instruction of the operation of the RAID hard disks can be found in the attached user's manual of the manu-
facturer.
5.1.3 Replacing the filter pad of Argus Processor
The filter pad of the A
RGUS
air.
The air filter is located behind the ventilation slits on the front of the A
•
Unlock the front cover of the A
•
Pull the handle of the filter mounting [2] into your direction!
•
Pull out the filter mounting to the right!
•
Remove the old filter pad!
•
Insert a new filter pad!
•
Insert the mounting into the A
•
Lock the front cover!
As long as the filter pad is not irreversibly blocked, cleaning it with a vacuum cleaner is also
an acceptable method to maintain a good air ventilation within the system!
Barco – Argus Workstation for Windows – DOC-3266-2 – Revision 06 – April 2004
P
has to be changed in intervals, depending on the grade of pollution of the
ROCESSOR
P
with the key!
RGUS
ROCESSOR
P
until the handle engages!
RGUS
ROCESSOR
stops lightening!
ROCESSOR
P
.
RGUS
ROCESSOR
__________________________________________________________________________
5. Maintenance
5-3