Table of Contents
Advertisement
Across the expansion card an elastic hold-down is mounted. It must also be removed. Therefore carefully loosen
the screw [4] on each side of the O
If you have removed the top cover and elastic hold-down of the Argus OmniBus in order to
add boards, be sure to replace both parts before powering up again!
Inside of the housing there is a transportation lock, which must also be removed to be able to insert expansion
cards. Loosen the screws 5, 6 and 7 and take out the plate.
Before closing the housing the transportation lock must be readjusted. Therefore first insert the plate, then turn
in the screws but do not tighten them. Push the plate as far towards the cards as possible. Just then tighten the
screws.
Barco – Argus Workstation for Windows – DOC-3266-2 – Revision 06 – April 2004
B
.
MNI
US
5
4
Position of screws on the side of A
6
7
__________________________________________________________________________
6. Advanced configuration
Figure 6-7
O
RGUS
MNI
Just then tighten the
Figure 6-8
Transportation lock of the O
MNI
B
US
B
US
6-5
Advertisement
Table of Contents
