Table of Contents
Advertisement
Example for the setup of the switcher definition file
The switcher definition file consists of multiple sections. Depending on the described system some sections can
be left out or must be used. Parts that are not used can as well be commented by means of the /* and */ char-
acters at the beginning, respectively end of the commented part. Twice a slash // comments all characters to its
right in the same line.
Here a simple example is given to explain the switcher definition file. It consists of an A
B
V
C
s. Three of these cards are combined to a distributed video. The following sections are used:
IG
IDEO
ARD
•
Grabber
To each B
V
C
IG
IDEO
ARD
•
DFRG
One or multiple Grabber get a name as video channel.
•
Sourcelist
All sources get a name and their video- / RGB
Sourcelists.
•
Route
Here it is determined which Sourcelist must be available at which input cards (Grabber) or DFRG.
•
Cables
This section describes the cabling of each source to the ports of each input card.
Grabber
s get the names BVC-1, BVC-2, ... , BVC-6 in the six Grabber sections. The grabber name
The six B
V
C
IG
IDEO
ARD
(here BVC-x) can be chosen freely unless it does not start with a digit or is a default name of the system (frg0,
dfrg0, qfrg0, ...). After the keyword device= the respective card is written. A list with the identifiers can be
found in
Table
6-26. The position of the card is indicated in square brackets.
Grabber "BVC-1"
{
device=frg2684[0];
}
Grabber "BVC-2"
{
device=frg2684[1];
}
Grabber "BVC-3"
{
device=frg2684[2];
}
Grabber "BVC-4"
{
device=frg2684[3];
}
Grabber "BVC-5"
{
device=frg2684[4];
}
Grabber "BVC-6"
{
device=frg2684[5];
}
Barco – Argus Workstation for Windows – DOC-3266-2 – Revision 06 – April 2004
an individual name is assigned.
GB-type gets defined. The sources get combined to groups, the
_________________________________________________________________________
4. Operating
system with six
RGUS
4-11
Advertisement
Table of Contents
