Installing Display Drivers For New Cards - Barco Argus User Manual

6.1.6 Installing display drivers for new cards

If A is operated with Windows 2000/XP XP and the display driver has already been installed, after inserting new
RGUS
graphic cards or RGB or video input cards a hardware check will detect the new cards when switching on A
The installation of the display drivers for the new components is started automatically.
After the installation is finished you have to confirm Finish:
Depending on the inserted hardware you are prompted to reboot A
No and to reboot just one time manually after the procedure explained above has been performed for all cards.
After the installation of the display drivers you have to configure the additional graphic
cards, see section
Barco – Argus Workstation for Windows – DOC-3266-2 – Revision 06 – April 2004
3.5.2 Configuring the display
New Hardware found and driver installed
. In this case it is recommended to click
RGUS
driver.
_________________________________________________________________________
6. Advanced configuration
RGUS
Figure 6-13
Figure 6-14
installation is finished
Figure 6-15
system settings change m settings change
6-12
.