Table of Contents
Advertisement
On the Locate Driver Files dialog, select Specify a location and continue with Next >.
Insert the CD Control Room Suite CRS-3045-C in the CD ROM drive. By defa
then open the file CRSindex.htm from the CD ROM. It shows an overview about software editions providing the
highest level of compatibility between the well-tested software module releases. If using multiple software from
the CD, it is recommended to select all modules from within one edition (Section Editions of the Control Room
Suite). If not, you can just install the latest release of the display driver (Section Releases of individual
Products).
Do not execute the setup.exe from the CD-ROM at that time!
Proceed as explained below instead!
The display drivers can be found under the path:
E:\Windows Drivers (OVS-2686)\Windows Drivers X.X
provided that the CD-ROM drive is mapped as drive E:. Within that directory choose the directory of the suitable
driver release e.g. Windows Drivers 3.40. In this directory there is for each type of graphic card an individ-
ual folder e.g. AGX3281 that contains the respective inf file:
E:\Windows Drivers (OVS-2686)\Windows Drivers 3.40\AGX3281\agx3281.inf
The driver release folder contains also an INF folder with further inf files. But these files
may NOT be selected!
The available directories and files in dependence of the used type of graphic card are listed in the table below:
AGX G
C
RAPHIC
ARD
UGX G
C
RAPHIC
ARD
When you selected the path click OK.
Barco – Argus Workstation for Windows – DOC-3266-2 – Revision 06 – April 2004
w instead!
AGX3000\agx3000.inf
AGX3281\agx3281.inf
M drive. By default the start page comes up, if not,
_________________________________________________________________________
3. Getting started
3-36
Advertisement
Table of Contents
