Installing Additional Hardware; Opening The Case Of Argus Processor - Barco Argus User Manual

6.1 Installing additional hardware

6.1.1 Opening the case of Argus Processor

Before opening the case, switch off A
power plugs! Remove all cables!
The boards of A
destroyed!
Loosen the screws 1 and 2 shown in the figure above on both sides of the case. For these screws as well as for
the screws inside of the A
P can be loosen with a 5.5 spanner as well.
ROCESSOR
Now you can easily remove the top cover.
If you have removed the top cover of the Argus Processor in order to add boards or memory
or to exchange the battery, be sure to replace the cover before powering up again!
Barco – Argus Workstation for Windows – DOC-3266-2 – Revision 06 – April 2004
hardware
Processor
contain CMOS components. Do not touch the components, they could be
RGUS
P you need a size 2 Phillips screwdriver. Some screws inside the A
RGUS ROCESSOR
with the power button on the front! Disconnect all
RGUS
Position of screws on the side of A
__________________________________________________________________________
6. Advanced configuration
y could be
RGUS
Screws of the case of the A
RGUS
Figure 6-1
P
ROCESSOR
RGUS
Figure 6-2
P
ROCESSOR
6-2