Barco Argus User Manual page 92

This section contains data that is used, if initial communication with the encoder is
Encoder Control
needed to prompt the encoder to send a stream. All fields must be filled in!
IP address of the encoder; may only be filled in if TCP has been selected for IP Protocol
IP Address
Port where the encoder listens to TCP start commands; may only be filled in if TCP has
Port
been selected for IP Protocol
Should remain udp, as indicated in the section Decoder control above. Only if a commu-
IP Protocol
nication with the encoder is required, tcp should be selected.
String that is sent to the specified encoder
Startstring
As unicast streams are only sent to one single IP address, only one Streaming Video Card at
a time is able to display one particular unicast stream.
The following table lists the encoder specific values that must be entered into the Streams Params Editor.
Encoder
VCS VideoJet 1000
The encoder setting
,
name stamping Time Stamping
instead.
Vbrick 4000
The encoder setting
flash will appear at the bottom side of the video
IMPath I-Volution 4000
NKFC FC-20
Scaler settings dialog box
In the Scaler Settings dialog box the settings for video processing in the O
Scaler Settings
adjustment of sharpness factor, default is 0
Sharpness
16 bpp (YUV 4:2:2, default), 16
Pixel Format
pending on input card)
Barco – Argus Workstation for Windows – DOC-3266-2 – Revision 06 – April 2004
ble to display one particular unicast stream.
Skip bytes at Start ...
16 6
should not be used; this disturbs the video image. The settings
Display stamping
,
Alarm mode stamping
0
should not be used; if there are big changes in the video image a green
Low Latency
0
36
V 4:2:2, default), 16 bpp (RGB 5:6:5) or 32 bpp (XRGB 8:8:8:8); (selection de-
Skip bytes at End ...
0
, ,
Video watermarking Displayed alarm message
0
0
0
MNI
_________________________________________________________________________
Parameters on the Streams Parameters Editor
Stream type TCP
Auto Off
can be used
Auto Off
Auto Off
Auto Off
Encoder dependant parameter values
S can be set.
CALER
Scaler Settings dialog box
4. Operating
Figure 4-8
PID
0
Camera
0
0
256
Table 4-12 2
Figure 4-9
4-22