Pioneer PE6000 Series User Manual page 146

Description of Function Codes
Output phase loss protection selection
P9-13
Setting Range
It is used to determine whether to perform output phase loss protection.
P9-14
P9-15
P9-16
It is used to record the types of the most recent three faults of the AC drive. 0 indicates no fault.
For possible causes and solution of each fault, refer to Chapter 8.
P9-17 Frequency upon 3rd fault
P9-18 Current upon 3rd fault
P9-19 Bus voltage upon 3rd fault
P9-20 DI status upon 3rd fault
Output terminal status
P9-21
AC drive status upon 3rd
P9-22
Power-on time upon 3rd
P9-23
Running time upon 3rd
P9-24
1st fault type
2nd fault type
3nd (last time) fault type
upon 3rd fault
fault
fault
fault
Default
0
1
It displays the frequency when the latest fault
occurs.
It displays the current when the latest fault occurs.
It displays the bus voltage when the latest fault
occurs.
It displays the status of all DI terminals when the
latest fault occurs.
The sequence is as follows:
If a DI is ON, the setting is 1. If the DI is OFF, the
setting is 0. The value is the equivalent decimal
number converted from the DI status.
It displays the status of all output terminals when
the latest fault occurs.
The sequence is as follows:
If an output terminal is ON, the setting is 1. If the
output terminal is OFF, the setting is 0. The value
is the equivalent decimal number converted from
the DI statuses.
Reserved
It displays the present power-on time when the
latest fault occurs.
It displays the present running time when the latest
fault occurs.
146
PE6000 User Manual
1
Disabled
Enabled
0-99