Pioneer PE6000 Series User Manual page 133

PE6000 User Manual
Frequency detection
hysteresis (FDT hysteresis 1)
P8-20
If the running frequency is higher than the value of P8-19, the corresponding DO terminal
becomes ON. If the running frequency is lower than value of P8-19, the DO terminal goes OFF
These two parameters are respectively used to set the detection value of output frequency and
hysteresis value upon cancellation of the output. The value of P8-20 is a percentage of the
hysteresis frequency to the frequency detection value (P8-19). The FDT function is shown in the
following figure.
Figure 5-16 FDT level
Detection range of frequency
P8-21
Setting Range
reached
Setting Range
Default
0.0%–100.0% (FDT1 level)
Default
0.00–100% (maximum frequency)
133
Description of Function Codes
5.0%
0.0%