Group P1: Motor Parameters - Pioneer PE6000 Series User Manual

PE6000 User Manual
It is used to bind the three running command sources with the nine frequency sources,
facilitating to implement synchronous switchover.
For details on the frequency sources, see the description of P0-03 (Main frequency source X
selection). Different running command sources can be bound to the same frequency source
If a command source has a bound frequency source, the frequency source set in P0-03 to
P0-07 no longer takes effect when the command source is effective.
Function
Code
P0-28
The PE6000 supports Modbus, PROFIBUS-DP bridge and CANopen bridge. Select a proper
protocol based on the actual requirements.

Group P1: Motor Parameters

Function
Parameter Name
Code
P1-00
P1-01 Rated motor power
P1-02
P1-03
P1-04
P1-05
rotational speed
Set the parameters according to the motor nameplate no matter whether V/F control or vector
control is adopted.
To achieve better V/F or vector control performance, motor auto-tuning is required. The motor
auto-tuning accuracy depends on the correct setting of motor nameplate parameters.
Parameter Name
Serial communication
protocol
0: Common asynchronous motor
Motor type 1: Variable frequency asynchronous
selection motor 2: Permanent magnetic
synchronous motor
0.1–1000.0 kW
Rated motor
1–2000 V
voltage
0.01–655.35 A (AC drive power ≤ 55 kW)
Rated motor
current 0.1–6553.5 A (AC drive power > 55 kW)
Rated motor
0.01 Hz to maximum frequency
frequency
Rated motor 1–65535
RPM
Description of Function Codes
Setting Range
0: Modbus protocol
1: PROFIBUS-DP bridge
2: CANopen bridge
Setting Range
89
Default
0
Default
0
Model
dependent
Model
dependent
Model
dependent
Model
dependent
Model
dependent