Static Ip Address Configuration-Receiver; Cross-Over Ethernet Cable Configuration-Flexpak6 - Novatel OEM6 Series User Manual

Ethernet Configuration
Antenna Cable
I/O Breakout Cable
6.2.1 Static IP Address Configuration—Receiver
Follow these steps to set up a static IP address on the OEM6 receiver:
1. Connect a computer to the OEM6 receiver using a null modem serial cable or USB cable.
2. Establish a connection to the receiver using either NovAtel Connect or another terminal program
such as Windows HyperTerminal. This connection is used to send the commands in this procedure to
the receiver.

For information about establishing a connection using NovAtel Connect, refer to the
Quick Start Guide for the product or NovAtel Connect Help.
3. Enable the Ethernet port on the receiver by entering:
ethconfig etha auto auto auto auto
4. Assign the TCP/IP port number used for the connection by entering:
icomconfig icom1 tcp :2000
5. Assign the receiver IP address, subnet mask and default gateway by entering:
ipconfig etha static 192.168.74.10 255.255.255.0 192.168.74.1
6. Save the new Ethernet settings by entering:
saveconfig
7. Log the IPCONFIG command and confirm the TCP/IP configuration by entering:
log ipconfig once
OEM6 Family Installation and Operation User Manual Rev 7
Figure 29: Cross-Over Ethernet Cable Configuration—FlexPak6
Antenna
FlexPak6
Cross-over
Ethernet Cable
Chapter 6
Computer
75