Novatel OEM6 Series User Manual page 158

Pin Signal Name
35 SPI4_MOSI
37 SPI4_MISO
39 GND
41 I2C2_SDA
43 I2C2_SCL
45 GND
47 TXD5
49 RXD5
51 RTS5
53 CTS5
55 GND
57 SDIO1_CMD
59 SDIO1_CLK
61 SDIO1_DAT0
63 SDIO1_DAT1
65 SDIO1_DAT2
67 SDIO1_DAT3
69 GND
71 HSUSB0_UID
73 HSUSB0_VBUS
75 HSUSB2_VBUS
158
Signal
Signal Type Direction Polarity
3.3V CMOS Output
3.3V CMOS Input
Open Drain IO
Open Drain IO
3.3V CMOS Output
3.3V CMOS Input
3.3V CMOS Output
3.3V CMOS Input
1.8V-3.0V Output
MMC
1.8V-3.0V Output
MMC
1.8V-3.0V IO
MMC
1.8V-3.0V IO
MMC
1.8V-3.0V IO
MMC
1.8V-3.0V IO
MMC
USB IO
USB Input
USB Input
OEM6 Family Installation and Operation User Manual Rev 7
Drive
Strength
(mA)
- 2 Serial Peripheral Interface #4,
Master Out / Slave In
- - Serial Peripheral Interface #4,
Master In / Slave Out
- -
- -
2
I C Interface #2, internally pulled
to 3.3 V
- -
- -
- 2 COM5 UART Signaling (3.3 V
CMOS logic)
- - COM5 UART Signaling (3.3 V
CMOS logic)
- 2 COM5 UART Signaling (3.3 V
CMOS logic)
- - COM5 UART Signaling (3.3 V
CMOS logic)
- -
- 12 SDIO / MMC Interface (Reserved
for internal use only. Not
available through API)
- 12

- 12
tolerant! Connection to 3.3 V
signals will damage the receiver.
- 12
- 12
- 12
-
- - USB0 IDentification. Leave
floating for normal operation
- - Used by the card to monitor
activity on the USB0 interface.
This pin cannot supply current to
hosted devices but must be
connected for normal operation.
- - Used by the card to monitor
activity on the USB2 interface.
This pin cannot supply current to
hosted devices but must be
connected for normal operation.
Description
These pins are NOT 3.3 V