Examining The Aux1 Status Word; Resolving An Error In The Aux1 Status Word - Novatel OEM6 Series User Manual

Chapter 7
7.2

Examining the AUX1 Status Word

Table 12 provides actions to take when your receiver has an error flag in the AUX1 status word .
Bit Set
0-2 (Reserved bits)
3 None. This bit indicates that Position Averaging is ON
4-6 (Reserved bits)
7 Connect the receiver via USB
8-10 Reduce the amount of logging on the USB ports
11-13 (Reserved bits)
AGC error on RF1 through RF4 respectively. To resolve, ensure the antenna cable is
14-17
connected and signal input level is within specification
18 Connect the receiver via Ethernet. See Section 4.7.7 Ethernet on page 65
19-21 Reduce the amount of logging on the Ethernet ports
22-24 Reduce the amount of logging on the NTRIP ports
25-27 Reduce the amount of logging on the Virtual COM ports
28-31 (Reserved bits)
88
Table 12: Resolving an Error in the AUX1 Status Word
OEM6 Family Installation and Operation User Manual Rev 7
Action to Resolve
Troubleshooting