Static Ip Address Configuration-Windows Xp With Sp3; Static Ip Address Configuration-Windows 7 - Novatel OEM6 Series User Manual

Chapter 6

The command assigns the following values to the OEM6 receiver:
These settings are examples only. The settings appropriate to your system may be
different.
8. Configure your computer with a static IP address.
For a computer using Windows XP Service Pack 3,refer to Section 6.2.2 Static IP Address Configu-
ration—Windows XP with SP3 on page 76.
For a computer using Windows 7, refer to Section 6.2.3 Static IP Address Configuration—Windows 7
on page 76.
6.2.2 Static IP Address Configuration—Windows XP with SP3
Follow these steps to set up a static IP address on a computer:
1. Click START | Settings | Network Connections.
The Network Connections window appears.
2. Right click on Local Area Connection and select Properties.
The Local Area Connection Properties window appears.
3. Click Internet Protocol (TCP/IP) and then click the Properties button.
The Internet Protocol (TCP/IP) Properties window appears.
4. Select the Use the following IP address radio button.
5. Enter the IP address, Subnet mask and Default gateway for the Ethernet port on the computer.

Ensure the Ethernet settings used for the computer are compatible with the Ethernet
settings on the OEM6 receiver.
For example, the following settings are compatible with the OEM6 receiver settings
used in Section 6.2.1 Static IP Address Configuration—Receiver on page 75:
6. Click the OK button.
The Local Area Connection Properties window appears.
7. Click the Close button.
8. Proceed to Section 6.2.4, Confirming Ethernet Setup on page 78.
6.2.3 Static IP Address Configuration—Windows 7
Follow these steps to set up a static IP address on a computer:
1. Click Start | Control Panel.
2. Click Network and Sharing Center.
3. Click the Local Area Connection link.
The Local Area Connection Status window appears.
4. Click the Properties button.
The Local Area Connection Properties window appears.
5. Select Internet Protocol Version 4 (TCP/IPv4) and then click the Properties button.
The Internet Protocol Version 4 (TCP/IPv4) Properties window appears.
76
ip address = 192.168.74.10
subnet mask = 255.255.255.0
gateway = 192.168.74.1
ip address = 192.168.74.11
subnet mask = 255.255.255.0
gateway = 192.168.74.1
OEM6 Family Installation and Operation User Manual Rev 7
Ethernet Configuration