Novatel OEM6 Series User Manual page 160

Pin Signal Name
8 IMUCTS / IMURXD-
10 GND
12 SYNCOUT
(EVENT_OUT7)
14 PV / EVENT_OUT3
16 EVENT_OUT4
18 EVENT_OUT5
20 EVENT_OUT6
22 GND
24 Reserved
26 EVENT_IN3
28 nRESETOUT /
EVENT_IN2
30 GND
32 USERIO3
34 USERIO4
36 USERIO5
38 USERIO6
160
Signal
Signal Type Direction Polarity
RS232 / Input
RS422
3.3V CMOS Output
3.3V CMOS Output
3.3V CMOS Output
3.3V CMOS Output
3.3V CMOS Output
3.3V CMOS Input
3.3V CMOS Output/
Input
3.3V CMOS IO
3.3V CMOS IO
3.3V CMOS IO
3.3V CMOS IO
OEM6 Family Installation and Operation User Manual Rev 7
Drive
Strength
(mA)
- - IMUCTS: RS232 Flow Control
(±25 V tolerant)
IMURXD-: RS422 Signaling (2 V
differential typical)
- -
Rising / 8 Synchronization Output.
Falling Identical to EVENT_OUT signals
Edge but dedicated for the use of an
attached IMU.
Rising / 8 Event Output. Outputs a user-
Falling specified timing signal. Can be
Edge synchronized with PPS.
Multiplexed with Position Valid
(PV)
Rising / 8 Event Output. Outputs a user-
Falling specified timing signal. Can be
Edge synchronized with PPS.
Rising / 8 Event Output. Outputs a user-
Falling specified timing signal. Can be
Edge synchronized with PPS.
Rising / 8 Event Output. Outputs a user-
Falling specified timing signal. Can be
Edge synchronized with PPS
- -
Rising / - Event Input (Mark Input). A
Falling transition on this pin is logged
Edge and time stamped. Weak pull up
internal to OEM638.
Rising / - nRESETOUT output. Outputs an
Falling active low pulse at system reset.
Edge Multiplexed with EVENT_IN2
(Mark2). Refer to the
IOCONFIG
pull up internal to OEM638 when
configured at Event Input
-
- 2 General Purpose IO (no internal
pull if resistor used as input)
- 2 General Purpose IO (no internal
pull if resistor used as input)
- 2 General Purpose IO (no internal
pull if resistor used as input)
- 2 General Purpose IO (no internal
pull if resistor used as input)
Description
command. Weak