Novatel OEM6 Series User Manual page 46

Chapter 4

1. Output from receiver self-tests may take some time. On startup, the OEM6 family
receiver is set to log the RXSTATUSEVENTA log ONNEW on all ports. See Section 5.4
RXSTATUSEVENT Log on page 69 for more details.
2. If NovAtel Connect is unable to locate the OEM6 family receiver, use a different COM
port to communicate with the receiver. When communication has been established,
issue a
ready for use.
3. XCOM1, XCOM2 and XCOM3 virtual ports can be generated by the receiver. However,
they are unlikely to appear as a port prompt as you cannot connect to these types of
ports using NovAtel Connect. Also, the XCOM ports are not available with the
SERIALCONFIG
INTERFACEMODE
(OM-20000129) for details on the virtual ports.
If the command was accepted, the receiver responds with:
<OK
If a command is entered incorrectly, the receiver responds with:
<ERROR:Invalid Message ID

Ensure the computer does not sleep or hibernate during a logging session or data will be
lost.
46
FRESET STANDARD
command. The original communications port should be
command but may be used with other commands, such as
and LOG . Refer to the
OEM6 Family Installation and Operation User Manual Rev 7
Operation OEM6 Cards and Enclosure
OEM6 Family Firmware Reference Manual
(or a more detailed message)