Novatel OEM6 Series User Manual page 105

Operating Temperature
Storage Temperature
Humidity
Random Vibration
Sinusoidal Vibration
Bump
Shock
Voltage
Allowable Input Voltage Ripple
Power Consumption
In-Rush Power Consumption
Antenna Connector
Acceptable RF Input Level
RF Input Frequencies
LNA Power
Electrical format
a
Bit rates
Signals supported
Electrostatic discharge protection Yes
OEM6 Family Installation and Operation User Manual Rev 7
ENVIRONMENTAL
-40C to +85C
-55C to +95C
MIL-STD-810G, Method 507.5 Procedure II (95%)
MIL-STD 810G Method 514.6, Category 24 (7.7 g RMS)
IEC 60068-2-6 (5 g)
ISO 9022-31-06 (25 g)
Operating: MIL-STD-810G, Method 516.6, Procedure I (40 g)
Non-operating: MIL-STD-810G, Method 516.6, Procedure V (75 g)
POWER REQUIREMENTS
+3.3 VDC ±5%
100 mV p-p maximum
<1.0 W typical, GPS L1/L2
1.1 W typical, GPS/GLONASS L1/L2
1.2 W typical, all on

Values can change with the number of satellites in view and the
firmware version. Use them as a guide for what you might expect but not as
absolute values.
6.0 A for less than 60 s (typical)
RF INPUT / LNA POWER OUTPUT
MCX female, 50  nominal impedance (See Figure on page 101)
L1: -122 to -87 (signal) dBm, -161 to -141 (noise) dBm/Hz
L2: -126 to -93 (signal) dBm, -161 to -141 (noise) dBm/Hz
GPS L1:
GPS L2:
GLONASS L1:
GLONASS L2:
Galileo E1:
BeiDou B1:
+5 VDC ±5%, 0-100 mA (supplied by card through center conductor of RF
connector).
The output current in all instances is limited to 100 mA and above an input
voltage of 6 V the output current limit is further reduced (derated) according
to:
Iout < 0.1W/ (Vin - 5V)
where Vin greater than 6 V and Vin is provided on Pin 1
INPUT/OUTPUT DATA INTERFACE
COM1
LVTTL
2400, 4800, 9600 (default), 19200, 38400, 57600, 115200, 230400,
460800 or 921600 bps. See Section 4.1.1, Serial Ports on Page 43
COM1_Tx, COM1_Rx
1575.42 MHz
1227.60 MHz
1593-1610 MHz
1237-1253 MHz
1575.42 MHz
1561.098 MHz
105