Choosing A Coaxial Cable; Mounting The Gnss Antenna - Novatel OEM6 Series User Manual

Installation FlexPak6
3.3.1

Choosing a Coaxial Cable

 To select a coaxial cable for the application, consult the NovAtel application note
RF Equipment Selection and Installation
to this application note if the application requires the use of cable longer than 30 m.
An appropriate coaxial cable matches the impedances of the antenna and receiver (50 ohms) and has a
line loss not exceeding 10.0 dB
receiver may not meet performance specifications. NovAtel offers several coaxial cables to meet GNSS
antenna interconnection requirements, including:
• 5, 15 and 30 m antenna cable with TNC connectors on both ends (NovAtel part numbers GPS-
C006, GPS-C016 and GPS-C032)

NovAtel recommends using high quality coaxial cables because an impedance mismatch,
possible with lower quality cables, produces reflections in the cable that increases signal
loss. Although other high quality antenna cables can be used, the performance
specifications of the OEM6 family receivers are warranted only when used with NovAtel
supplied accessories.
3.3.2

Mounting the GNSS Antenna

The GNSS receiver is designed to operate with any of the NovAtel single, dual and triple-frequency
GNSS antenna models. See Section 3.3 Selecting a GNSS Antenna on page 36 for more information.
When installing the antenna:
• Choose an antenna location with a clear view of the sky so each satellite above the horizon can
be tracked without obstruction. For more information on RF signal propagation and multipath,
refer to the NovAtel application note
Multipath at www.novatel.com/support/.
• Mount the antenna on a secure, stable structure capable of safe operation in the specific
environment.
OEM6 Family Installation and Operation User Manual Rev 7
available at www.novatel.com/support/. Also refer
.
If the limit is exceeded, excessive signal degradation may occur and the
APN-008 Discussions on RF Signal Propagation and
Chapter 3
APN-003
37