Resolving An Error In The Receiver Status Word - Novatel OEM6 Series User Manual

Troubleshooting
Bit Set
Check the Error Word in the RXSTATUS log. See also Table 10, Resolving a Receiver Error Word
0
on page 86
Check temperature ranges in the ENVIRONMENTAL table sections Technical Specifications
1
starting on page 122
2 See Section 2.4, Power Supply Requirements, page 24
3
See Section 2.3, Selecting a GNSS Antenna, page 22, Section 2.3.1, Choosing a Coaxial Cable,
4
page 23, Section 2.3.3, Connecting the Antenna to the Receiver, page 24, Section 4.7.6, Antenna
5
LNA Power, page 64
6
Check the CPU idle time. Check for unnecessary logging. Check for simultaneous use of
7
functionality, for example, API and RTK
8
9
See Table 7, Serial Ports Supported on page 43
10
11
15-17 Reserved
When the receiver has tracked GNSS satellites long enough for a valid almanac to be received,
18
this bit will be set to 0.
19 None. This bit only indicates if the receiver has calculated a position.
None. This bit is a status bit indicating if the receiver's position has been manually fixed and does
20 not represent a problem. Refer also to the FIX command in the
Manual (OM-20000129)
None. This bit indicates if clock steering has been manually disabled. Refer also to the FRESET
21
command in the
None. This bit only indicates if the clock model is valid. Refer also to the FRESET command in the
22
OEM6 Family Firmware Reference Manual
None. This bit indicates if the phase-lock-loop is locked when using an external oscillator. Refer
23
also to the FRESET command in the
Check the CPU idle time. Check for unnecessary logging. Check for simultaneous use of
24
functionality, for example, API and RTK
None. This bit indicates if any bits in the auxiliary 3 status word are set. The auxiliary 3 word
29 provides status information and does not contain any new information on problems. Refer also to
the FRESET command in the
None. This bit indicates if any bits in the auxiliary 2 status word are set. The auxiliary 2 word
30 provides status information and does not contain any new information on problems. Refer also to
the FRESET command in the
None. This bit indicates if any bits in the auxiliary 1 status word are set. The auxiliary 1 word
31 provides status information and does not contain any new information on problems. Refer also to
the FRESET command in the
OEM6 Family Installation and Operation User Manual Rev 7
Table 11: Resolving an Error in the Receiver Status Word
Action to Resolve
OEM6 Family Firmware Reference Manual
OEM6 Family Firmware Reference Manual
OEM6 Family Firmware Reference Manual
OEM6 Family Firmware Reference Manual
OEM6 Family Firmware Reference Manual
OEM6 Family Firmware Reference
(OM-20000129)
(OM-20000129)
Chapter 7
(OM-20000129)
(OM-20000129)
(OM-20000129)
(OM-20000129)
87