D Flexpak6 Technical Specifications; D.1 Flexpak6 - Novatel OEM6 Series User Manual

Appendix D

D.1 FlexPak6

FPk6
ANT
PWR
COM1
COM2
USB
Ethernet, CAN, I/O
Size
Weight
Mounting System
Operating
Storage Temperature
Humidity
Immersion
Random Vibration
Sinusoidal Vibration
Bump
Shock
Acceleration
Input Voltage
Power Consumption
In-Rush Current
a. COM2 can be can be dynamically changed to RS-422 by grounding I/O pin 9. Refer to Table 30,
FlexPak6 Port Pin-Out Descriptions on Page 138 for details.
137
FlexPak6 Technical Specifications
INPUT/OUTPUT CONNECTORS
TNC female jack, 50  nominal impedance
+5 VDC (±5%)100 mA max (output from FlexPak6 to antenna/LNA)
4-pin LEMO
9-pin DB9 (maximum baud rate 921600)
a
9-pin DB9 (maximum baud rate 921600)
mini-AB
DB-HD15
45 x 147 x 123 mm
337 g maximum
Integral flange with two 7 mm (9/32 inch) diameter mounting holes 133 mm
(5.25 inches) apart
ENVIRONMENTAL
-40C to +75C
-40C to +85C
MIL-STD-810G, Method 507.5, Procedure II (95%)
IEC 60529 IPX7
MIL-STD-810G, Method 514.6, Category 24 (20 to 2000 Hz, 7.7 g RMS)
SAE J1211 (10 Hz to 1000 Hz, 4 g)
IEC 60068-2-27 (10 g)
MIL-STD-810G, Method 516.6, Procedure 1 (40 g)
MIL-STD-810G, Method 513.6, Procedure II (4 g, 8 g, 12 g, 16 g)
POWER REQUIREMENTS
+6 to +36 VDC
Typical 1.8 W (power consumption values for GPS L1/L2 at 6 VDC with
Ethernet disabled)
Maximum 3.1 W
6.6 A for less than 60 s (typical)
PHYSICAL
OEM6 Family Installation and Operation User Manual Rev 7