Novatel OEM6 Series User Manual page 115

Operating Temperature
Storage Temperature
Humidity
Random Vibe
Sine Vibe
Bump / Repetitive shock
Shock
Input voltage
Allowable Input Voltage Ripple
Power Consumption
In-Rush Power Consumption
Antenna Connector
Acceptable RF Input Level
RF Input Frequencies
LNA Voltage
LNA Current
LNA Current Limit
OEM6 Family Installation and Operation User Manual Rev 7
ENVIRONMENTAL
-40C to +85C
-55C to +95C
95% non-condensing
MIL-STD-810G Method 514.6 (category 24, 7.7 g RMS)
IEC 60068-2-6 (Test Fc - 5 g)
ISO 9022-31-06 (25 g)
MIL-STD-810G Method 516.6 (40 g)
POWER REQUIREMENTS
+3.3 VDC +5%/-3%
100 mV p-p maximum
1.9 W typical, GPS L1/L2
<2.0 W typical, GPS+GLONASS L1/L2
<2.1 W typical, GPS+BDS+GLONASS L1/L2/B1/B2

Values can change with the number of satellites in view and the firmware
version. Use them as a guide for what you might expect but not as absolute values.
6.0 A for less than 60 s (typical)
RF INPUT
MMCX female, 50  nominal impedance (See Figure on page 113)
L1: -122 to -87 (signal) dBm, -161 to -141 (noise) dBm/Hz
L2: -126 to -93 (signal) dBm, -161 to -141 (noise) dBm/Hz
GPS L1: 1575.42 MHz
GPS L2: 1227.60 MHz
GLONASS L1: 1593-1610 MHz
GLONASS L2: 1237-1253 MHz
Galileo E1: 1575.42 MHz
BeiDou B1: 1561.098 MHz
BeiDou B2: 1207.140 MHz
LNA POWER OUTPUT
5 V (range 4.5 to 5.25) to each antenna
(supplied by card through center conductor of RF connector)
0-100 mA to each antenna in dual antenna use case
0-200 mA to primary antenna in single antenna use case
The output current for dual antenna use is limited to 100 mA for each antenna. Above
an input voltage of 6 V, the output current limit is further reduced (derated) according
to:
Iout < 0.1W/ (Vin - 5V) where Vin is from 6 V to 12 V (J1101, Pin 1)
The output current for single antenna use is limited to 200 mA on the primary antenna.
Above an input voltage of 6 V, the output current limit is further reduced (derated)
according to:
Iout < 0.15W/ (Vin - 5V) where Vin is from 6 V to 12 V (J1101, Pin 1)
115