J4001 Main Header Pinout And Signal Description - Novatel OEM6 Series User Manual

Pin 2
Pin 1
Pin Signal Name
1 VIN
2 PV
3 USB0_D+
4 GND
5 USB0_D-
6 GND
7 PPS
8 GND
9 VARF
(EVENT_OUT1)
10 GND
11 EVENT_IN1
(MKI)
12 GND
13 STATUS_RED
OEM6 Family Installation and Operation User Manual Rev 7
Figure 77: J4001 Main Header Pinout and Signal Description
Signal
Signal Type Direction Polarity
PWR Input
3.3V CMOS Output
Analog IO
GND
Analog IO
GND
3.3V CMOS Output
GND GND
3.3V CMOS Output
GND GND
3.3V CMOS Input
GND GND
3.3V CMOS Output
Drive
Strength
(mA)
- Supply Input (4.5 V-36 VDC).
The wide-range supply input on
J4101 is preferred for new designs
(as it has a higher max current rating).
Active 2 Position Valid Output. If high,
High indicates a valid GNSS position.
- USB0 D+ (differential signal). USB0
supports 480/12/1.5Mbps data
transfers.
-
- USB0 D-(differential signal). USB0
supports 480/12/1.5Mbps data
transfers.
-
Active 8 Pulse Per Second. Outputs one pulse
b per second, synchronized to GNSS
High
time.
-
8 Variable Frequency Output. Outputs a
user specified timing signal. Can be
synchronized with PPS. Weak pull up
internal to OEM638
-
Rising - Mark Input. Transitions on this pin are
time stamped and reported in logs (or
b
edge
used by application code).
-
Active 2 Red Status LED Control. Used to
High indicate the state of the receiver or
provide error codes.
Pin 40
Pin 39
Description
153