Static Ip Address Configuration-Receiver; Figure 31: Cross-Over Ethernet Cable Configuration-Oem7 Receiver - Novatel SMART7 Installation And Operation Manual

Chapter 6 Ethernet Configuration
Figure 31: Cross-Over Ethernet Cable Configuration—OEM7 Receiver
6.2.1 Static IP Address Configuration—Receiver
Follow these steps to set up a static IP address on the OEM7 receiver:
1. Connect a computer to the OEM7 receiver using a null modem serial cable.
2. Establish a connection to the receiver using either NovAtel Connect or another terminal pro-
gram. This connection is used to send the commands in this procedure to the receiver.
For information about establishing a connection using NovAtel Connect, refer to
the Help within NovAtel Connect.
NovAtel Connect version 2.0 or greater is required for OEM7 receivers.
Download the latest NovAtel Connect software and documentation from
www.novatel.com/novatel-connect.
3. Enable the Ethernet port on the receiver by entering:
ETHCONFIG ETHA AUTO AUTO AUTO AUTO
4. Assign the TCP/IP port number used for the connection by entering:
ICOMCONFIG ICOM1 TCP :2000
5. Assign the receiver IP address, subnet mask and default gateway by entering:
IPCONFIG ETHA STATIC 192.168.74.10 255.255.255.0 192.168.74.1
The command assigns the following values to the OEM7 receiver:
These settings are examples only. The settings appropriate to your system may
be different.
6. Save the new Ethernet settings by entering:
SAVEETHERNETDATA
7. Log the IPCONFIG command and confirm the TCP/IP configuration by entering:
SMART7 Installation and Operation User Manual 0C
IP address = 192.168.74.10
Subnet mask = 255.255.255.0
Gateway = 192.168.74.1
92