Novatel OEM6 Series User Manual page 116

Electrical format
a
Bit rates
Signals supported
Electrostatic discharge protection
Electrical format
a
Bit rates
Signals supported
Electrostatic discharge protection
Electrical format
a
Bit rates
Signals supported
Electrostatic discharge protection
Electrical format
Bit rates
Signals supported
Electrical format
Bit rates
Signals supported
Physical Layer
a. Baud rates higher than 115,200 bps are not supported by standard PC hardware. Special computer hardware
may be required for higher rates, including 230400 bps, 460800 bps and 921600 bps.
b. COM3 is disabled by default. See Table 3 OEM6 Card Default Serial Port Configurations in the
Installation and Operation User Manual
c. Event2 is enabled by default, but is multiplexed with CAN1. CAN functionality must be disabled for Event2 to
work properly. See Table 3 OEM6 Card Default Serial Port Configurations in the
Operation User Manual
OEM6 Family Installation and Operation User Manual Rev 7
INPUT/OUTPUT DATA INTERFACE
COM1
LVTTL
300, 1200, 2400, 4800, 9600 (default), 19200, 38400, 57600, 115200, 230400,
460800 or 921600 bps. See Section 4.1.1 Serial Ports in the
Installation and Operation User Manual
COM1_Tx, COM1_Rx
No
COM2
LVTTL
300, 1200, 2400, 4800, 9600 (default), 19200, 38400, 57600, 115200, 230400,
460800 or 921600 bps. See Section 4.1.1 Serial Ports in the
Installation and Operation User Manual
COM2_Tx, COM2_Rx
No
COM3
b c
LVTTL
300, 1200, 2400, 4800, 9600 (default), 19200, 38400, 57600, 115200, 230400,
460800 or 921600 bps. See Section 4.1.1 Serial Ports in the
Installation and Operation User Manual
COM3_Tx and COM3_Rx
No
CAN BUS
LVTTL (requires external CAN transceiver)
1 Mbps maximum.
CAN Bus throughput is determined by slowest device on the bus
CAN1 and CAN2
Conforms to USB 2.0
Full-speed USB
USB D (+), USB D (-)
ETHERNET
None
(OM-20000128).
(OM-20000128).
(OM-20000128)
(OM-20000128)
(OM-20000128)
d
USB
OEM6 Family
OEM6 Family
OEM6 Family
OEM6 Family
OEM6 Family Installation and
116