Table of Contents
Advertisement
6.5 Network Configuration
The unit's network values display when you select Configuration->Network
Settings.
The following sections describe the configurable parameters on the Network
Settings page.
Info:
It is possible to reload factory default IP setup from the front panel. To reload
press CONTROL_LOCK button, press and hold OUTPUT_LOCK button and
press LOAD PRESET button. TAKE, LOAD PRESET and SAVE PRESET
buttons will blink, and after a short while the router will beep. The router has
reloaded its default IP setup (IP address: 192.168.254.254, SUBNET MASK:
255.255.0.0)
6.5.1 Automatic IP Address Configuration
The matrix switcher supports three of the most used automatic IP configuration
protocols.
To assign IP address automatically:
Step 1
Step 2
Step 3
Step 4
BOOTP
DHCP
AutoIP
Info:
Disabling BOOTP, DHCP, and AutoIP (all three checkboxes) is not advised as the
only available IP assignment method will then be ARP or serial port.
Click on Configuration menu
Select Network Settings
Select Obtain IP address automatically
Enter the following (as necessary):
Select Enable to permit the Bootstrap Protocol
(BOOTP) server to assign the IP address from
a pool of addresses automaticaly.
Select Enable to permit the Dynamic Host
Configuration Protocol (DHCP) server to
assign leased IP address to the matrix unit
automatically.
Select Enable to permit the matrix to generate
an IP in the 169.254.x.x address range with
Class B subnet.
MX32x32DVI-Pro
User's Manual
Page 57 / 79
Advertisement
Table of Contents
