Supplementary Operating Instructions For Profibus; Requirements; Adjusting The Pump; General - ProMinent DULCO flex Control Original Operating Instructions

Supplementary operating instructions for PROFIBUS

3
Supplementary operating instructions for PROFIBUS

3.1 Requirements

3.2 Adjusting the pump

3.2.1 General

3.2.2 Switch PROFIBUS
46
3.1 Requirements............................................................. 46
3.2 Adjusting the pump..................................................... 46
3.2.1 General.................................................................... 46
3.2.2 Switch PROFIBUS
3.2.3 Setting the slave address........................................ 47
3.3 Special features in active PROFIBUS
3.3.1 General.................................................................... 48
3.3.2 Displays................................................................... 48
3.3.3 LEDs on the PROFIBUS
3.3.4 Using the metering monitor...................................... 49
3.4 Installation................................................................... 49
3.5 Operation.................................................................... 51
3.5.1 General.................................................................... 51
3.5.2 GSD file................................................................... 51
3.5.3 DULCO flex Control DFXa, DFXa data objects....... 51
Personnel must be familiar with the contents of the "Peristaltic
metering pump DULCO flex Control, DFXa"!
The pump must have the identity code feature "Control type": "R"
PROFIBUS ® DP interface M 12". The
available in the operating menu. (When
'Settings è PROFIBUS' also appears in the operating menu.)
The pump with PROFIBUS
way as the standard pump, with the addition of the bus function-
ality.
The adjustment process is cancelled in the event
of a pause lasting longer than 60 s.
Using the connected PROFIBUS
represents a device with slave functionality in conformity with DP-
V1. This means that the payload is transferred both cyclically and
acyclically.
® to active / inactive
In order for the pump to be activated using the PROFIBUS
'Fieldbus' must be set to 'Active' in the operating menu.
1. Press the
ð The cursor immediately goes to
®
® to active / inactive................... 46
module........................... 49
®
'Fieldbus' menu item is then
'Fieldbus è Active' is set,
functionality is adjusted in the same
®
® module, the PROFIBUS
[Menu] key to access the 'Menu' .
®
® operation....... 48
® pump
® ,
'Information' .