Operation; General; Gsd File; Dulco Flex Control Dfxa, Dfxa Data Objects - ProMinent DULCO flex Control Original Operating Instructions

Terminal resistance

3.5 Operation

3.5.1 General

3.5.2 GSD file

3.5.3 DULCO flex Control DFXa, DFXa data objects

Tab. 32: Status and control
Module/ Index Name
slot
1 1 State
Supplementary operating instructions for PROFIBUS
CAUTION!
–
–
–
If the pump is the last bus device connected to the PROFIBUS
cable, it must be connected completely as a termination using the
PROFIBUS ® terminating resistance, pluggable (order no. 1036622)
see EN 50170. The PROFIBUS
protection against contact and moisture.
P_DE_0079_SW
Using the connected PROFIBUS
represents a device with slave functionality in conformity with DP-
V1. This means that the payload is transferred both cyclically and
acyclically.
The GSD file must be used to configure the master. It describes all
features of the pump in PROFIBUS
nosis, modules, slots). The GSD file can be downloaded from the
PROFIBUS ®
name is clearly indicated: DFXA1137.GSD .
Module Identifi‐ Type
name cation
(hex)
Status 40.83 u32
Degree of protection IP 65 applies only to a
plug/socket combination that has been
screwed together!
In ambient conditions requiring protection
against contact and moisture up to IP 65,
cables with moulded M12 industrial connectors
must be used.
The degree of protection IP 65 applies only to
an unwired pump (with PROFIBUS
IP 65-capable covers are placed over the M12
industrial sockets! The cover included in the
delivery does not guarantee chemical resist‐
ance.
terminating resistance has IP 65
®
® module, the PROFIBUS
operation (keywords, diag‐
®
website and from the ProMinent website. The file
Data Description
flow *
Bit
R 0
1
® module), if
®
® pump
Name Function
Motor Motor state
0 = Motor idle,
1 = Motor run‐
ning)
- -
®
51