Leds On The Profinet ® Module; Using The Metering Monitor - ProMinent DULCO flex Control Original Operating Instructions

Supplementary Operating Instructions for PROFINET
4.3.3 LEDs on the PROFINET
LED 1 (left) - module operating status
Signal
Off
Green
Green flashing
LED 2 (right) - module status
Signal
Off
Green
Green flashing, single flash
Green flashing, 1 Hz
Red
Red, single flash
Red, double flash
Red, triple flash
Red, quadruple flash

4.3.4 Using the metering monitor

64
®
Stop PROFINET
PROFI
NET
FINET . The master has sent the pump a corresponding telegram.
®
Stop manual: The pump has been stopped using the
[Start/Stop] key. The master has sent the pump a corresponding
telegram.
Connection error: If the pump loses its connection to the PRO‐
FINET ® (as soon as the BUS cable is removed, the bus master is
switched to "Stop" status or the bus master becomes inoperative,
for example), then the
Error module: If the pump loses its connection to the BUS
module (as soon as the BUS module is removed or if communica‐
tion between the BUS module and pump is interrupted for other
reasons, for example), the error symbol
appear.
® module
Cause
The module has no supply voltage or connection.
The module and the master are exchanging information.
The module has been initialised.
Cause
The module has not been initialised.
The module has been initialised / normal mode
The module has been initialised and there are diagnostic mes‐
sages.
DCP flash
Serious exception error
Configuration error
IP address error
Station name error
Internal error
The "Metering monitor" socket must be used to use the metering
monitor in PROFINET
for the "Flow" status bit. The metering monitor can be switched on
and off using the PROFINET
'FlowControl' parameters.
and/or
® : The pump has been stopped using PRO‐
error symbol and the
and the
® mode. The pump then transmits
® by means of the
symbol appear.
symbol
'available'
'Metering monitor'