Special Features In Active Profinet ® Mode; General; Displays - ProMinent DULCO flex Control Original Operating Instructions

4.3 Special features in active PROFINET

4.3.1 General

4.3.2 Displays

Supplementary Operating Instructions for PROFINET
4. In the 'PROFINET' menu, you can undertake the following
for the pump:
'IP address ...'
n
– ... (set).
'Subnet address ...'
n
– ... (set).
'Gateway address ...'
n
– ... (set).
'DNS address ...'
n
– ... (set).
dhcp ...
n
– ... (activate or deactivate).
'Pump name ...'
n
– ... (read off / change).
Origin of the designations
The different names and/or addresses represent
user-specific information and are the responsibility
of the system operator.
® mode
In PROFINET
ually set or programmed! To do this, set the PRO‐
FINET ® to 'Inactive' .
[Clickwheel] it is possible to switch between the con‐
Using the
n
tinuous displays at any time, as in the other operating modes.
This does not affect the operation of the pump.
When PROFINET ® operation is selected, the settings from the
n
last operating mode without PROFINET
trast, the settings made via PROFINET
only apply as long as the pump is linked to the PROFINET
'stroke counter' (total number of strokes) and the
Only the
'quantity counter' (total number of litres) continue to be
counted and saved.
The pump stops if it is set to PROFINET
n
vated again by pressing the
to give the Start command.
When PROFINET mode is running there are further identifiers in
®
the operating indicator.
The commonly used identifiers can be found in the
"Control elements" chapter in the "Peristaltic
metering pump DULCO flex Control, DFXa".
® mode, the pump cannot be man‐
are applied. By con‐
®
® are not saved! They
® mode. It can be acti‐
[Stop/Start] key. Use the BUS
®
® .
63