Configuring Profinet - ProMinent DULCO flex Control Original Operating Instructions

Supplementary Operating Instructions for PROFINET

4.2.3 Configuring PROFINET

Checking configuration on pump
62
®
4. To switch from
and press it.
ð The pump saves the
'Settings è PROFINET' menu also appears.
The
The pump is in "Stop" mode. To activate it, press the
[Stop/Start] key. Use the BUS to give the Start command.
While the PROFINET
monitoring, metering monitoring and external control (pause, con‐
tact input, analogue input) will function. In the appropriate oper‐
ating mode, they produce the reactions you would expect if the
pump had no PROFINET® functionality - see pump operating
instructions. The pump sends corresponding information via the
PROFINET ® to the master (PLC, PC etc.).
The DULCO flex Control DFXa, DFXa is factory-set to
metering.
Even if the fieldbus is set to inactive, the master has read-only
access to the pump data defined in its GSDML file.
If the PROFINET ® is set to
mode previously selected are reloaded.
If the pump is switched to another operating mode, it stops and can
only be restarted using the
®
The pump can always be configured via the PROFINET
less of whether PROFINET is activated or not.
Fieldbus mode must be enabled to be able to control the pump via
the PROFINET ® .
Normally, the pump is configured using the PLC and not using the
'PROFINET' menu. To do this, use the PLC to enter a
pump's
name for the pump.
The settings for the IP address, subnet, ... are undertaken by the
PLC. The pump's menu can be used to check the values:
Requirement:
The PROFINET ® is activated - see
pump' on page 61 .
1. To access the
[arrow keys] to select the 'Settings' menu item and
2. Use the
confirm with the
'Operating mode' menu appears.
ð The
[arrow keys] to select the 'PROFINET' menu item
3. Use the
and confirm with the
'Inactive' to 'Active' , turn the [Clickwheel]
'Active' setting.
'Active' , all external inputs such as level
® is
'Inactive' , the settings for the operating
[Stop/Start] key.
Ä Chapter 4.2 'Adjusting the
'Menu' : press the [Menu] key
[OK] key
[OK] key
'Automatic'
– regard‐
®