Special Features In Active Profibus ® Operation; General; Displays - ProMinent DULCO flex Control Original Operating Instructions

Supplementary operating instructions for PROFIBUS
3.3 Special features in active PROFIBUS

3.3.1 General

3.3.2 Displays

48
®
The PROFIBUS ® address must always be entered as 3 digits
(addresses from "002" to "125"):
1. 1. option: Turn the
reached and then press the
2.
2. option: Press the
digit setting. Set the number using the
[Priming] key. The cursor moves to the next
using the
number, and so on .
® operation
The pump cannot be manually set or programmed
in PROFIBUS
FIBUS to 'Inactive' .
®
[Clickwheel] it is possible to switch between the con‐
Using the
n
tinuous displays at any time, as in the other operating modes.
This does not affect the operation of the pump.
When PROFIBUS operation is selected, the settings from the
®
n
last operating mode without PROFIBUS
ever, settings made using the PROFIBUS
only apply as long as the pump is linked to the PROFIBUS
'stroke counter' (total number of strokes) and the
Only the
'quantity counter' (total number of litres) continue to be
counted and saved.
If the pump is set to PROFIBUS
n
activated again by pressing the
BUS to give the Start command.
There are additional identifiers in the operating display when PRO‐
FIBUS operation is running.
®
The commonly used identifiers can be found in the
"Control elements" chapter in the "Peristaltic
metering pump DULCO flex Control, DFXa".
Stop PROFIBUS : The pump has been stopped using PRO‐
®
PROFI
BUS
FIBUS ® . The master has sent the pump a corresponding telegram.
Stop manual: The pump has been stopped using the
[Start/Stop] key. The master has sent the pump a corresponding
telegram.
Connection error: If the pump loses its connection to the PRO‐
FIBUS (as soon as the BUS cable is removed or the bus master
®
becomes inoperative, for example), the
symbol appear.
[Clickwheel] until the desired value is
[Clickwheel] .
[Priming] key to change to digit-by-
[Clickwheel] and save
® operation! To do this, set the PRO‐
® are applied. How‐
® are not saved! They
operation, it stops. It can be
®
[Stop/Start] key. Use the
error symbol and the
.
®