Enable Ip Static_Remote_Routes; Udp_Broadcast_ Forwarding; Network <Network_Name; Enable Ipx - 3Com 3C421600A Reference Manual

92 C 4: R
HAPTER OUTER
enable ip
static_remote_routes
enable ip
udp_broadcast_
forwarding

enable ipx

network
<network_name>
C R
OMMAND EFERENCE
discarded. Of the two drop commands, this is the highest level of
security. Default: enabled.
partial TCP headers (offset=1) — Protocol field in the IP packet header
(in this case, TCP). Packets of this type can be discarded. Lower level of
security than All fragmented packets (Drop_all_fragoffset1). Default:
enabled.
all header options — All choices in the IP Options field of the IP
header. IP options may be generated as an attack to get past routing
tables. To avoid this situation in security, packets of this type can be
discarded. Of the two disallow commands, this is the highest level of
security. Default: disabled.
source route options — Another choice in the IP Options field of the IP
header. Particular path the sender chooses to take through the
network to reach its destination, as specified in the sender packet IP
header. Packets of this type can be discarded, although this is a lower
level of security than All Header Options. Default: disabled.
Enables the statically defined remote routes, which you defined using the
add ip route command. You can list the currently defined IP routes
using list ip routes. Use the show ip routing command to
view edits.
Permits the RAS 1500 to forward UDP packets from source ports on the
private network. These ports, from which UDP packets are forwarded, are
defined using the add ip udp_bcast_forwarding_port.
Normally, to save bandwidth, routers do not forward UDP packets.
However, since some applications run by the user on the private network
require the forwarding of UDP packets, this command can be enabled or
disabled, as needed.
Do not enable the RAS 1500 for UDP broadcast forwarding if your
network contains loops.
Enables the specified IPX network, which you previously defined using
the add ipx network command. You can list currently defined IPX
networks using list ipx networks.