3Com 3C421600A Reference Manual page 196

196 C 4: R
HAPTER OUTER
show ipx network
<network_name>
or show ipx network
settings
C R
OMMAND EFERENCE
Decompression Errors — Sum of incoming packets discarded due
to compression errors.
OUTPUT COUNTERS
Total Packets Transmitted — Sum of IPX packets transmitted.
Forwarded Packets — Sum of IPX packets forwarded.
Local Transmits — Sum of IPX packets transmitted to local hosts.
Local Malformed Transmits — Sum of IPX packets supplied locally
containing structural errors.
Discarded — Sum of outgoing packets discarded.
Filtered Out — Sum of packets filtered out before transmission.
Compression Errors — Sum of outgoing packets discarded due to
compression errors.
Socket Open Failures — Sum of outgoing packets discarded because a
socket was not available.
Displays parameter settings for the specified IPX network. You can modify
most of these values using the set ipx network command. It lists the
following:
Interface — Interface this IPX network uses, rm0/eth:1.
Network address — Network address of this IPX network.
Frame Type — Frame type used by the interface (ETHERNET II,
NOVELL_8023, SNAP, or DSAP).
Maximum Packet Size — Maximum allowable packet size for this IPX
network. Default: 1500.
Status — Operational state of the network. Default: ENABLED.
Network Delay (ticks) — Time in number of ticks it takes to reach this
IPX network. Default: 1.
Network Learning Retries — Number of times this network resends
packets to discover its directly connected neighbors.
Diagnostics — Sending of diagnostic packets. Default: ENABLED.
NetBIOS — Support. Default: ENABLED.
NetBIOS Name Caching — Support. Default: DISABLED.