3Com 3C421600A Installation Manual
I/o module for superstack ii remote access system
Hide thumbs
Also See for 3C421600A:
- Management manual (300 pages) ,
- Reference manual (269 pages) ,
- Quick setup manual (74 pages)
Advertisement
®
Part No. 1.024.1911 Rev 2.00
December, 1999
I/O M
ODULE
G
UIDE
S
S
II R
UPER
TACK
This guide describes how to install V.34 (analog), ISDN-BRI or a
combination of V.34 and ISDN-BRI modules into the RAS 1500 Base Unit
or RAS 1500 Expansion unit. It includes the following:
Overview
Related Documentation
Contacting 3Com
Before You Begin
Installing and Removing I/O Modules
Swapping I/O Modules
Powering the Unit On or Off
Visit 3Com's web site (http://www.3Com.com/ras1500) for the latest
SuperStack II Remote Access System 1500 code and documentation.
I
NSTALLATION
A
S
EMOTE
CCESS
1500
YSTEM
Advertisement
Table of Contents
Related Manuals for 3Com 3C421600A
Summary of Contents for 3Com 3C421600A
- Page 1 V.34 and ISDN-BRI modules into the RAS 1500 Base Unit or RAS 1500 Expansion unit. It includes the following: Visit 3Com’s web site (http://www.3Com.com/ras1500) for the latest SuperStack II Remote Access System 1500 code and documentation. Part No. 1.024.1911 Rev 2.00...
- Page 2 Use this chart as a reference when you need to contact 3Com. Contacting 3Com 3Com Corp. - 5400 Bayfront Plaza - P.O. Box 58145 - Santa Clara, CA - 95052-8145 Internet For a complete listing of support and contact numbers, refer to Appendix E, “Technical Support,”...
- Page 3 Installing and Removing I/O Modules Installing an I/O You can install V.34 (analog), ISDN-BRI or a combination of V.34 and Module ISDN-BRI modules in the RAS 1500 or RAS 1500 Expansion unit. Use the following steps to install an I/O module: CAUTION: The modules are not hot-swappable.
- Page 4 I/O M ODULE NSTALLATION Removing an I/O Module Use the following steps to remove an I/O module: CAUTION: The modules are not hot-swappable. Power off the unit before installing, removing, or exchanging the modules. Failure to do so could damage the modules. 1 Remove the AC power cord from the back of the RAS 1500 or RAS 1500 Expansion to power off the unit.
- Page 5 Powering the Unit To power on the RAS 1500 Base Unit or RAS 1500 Expansion unit: On or Off 1 Connect the power cord to the AC power port of the unit. 2 Plug the power cord into the AC power supply source. The unit starts up. To power off the RAS 1500 or RAS 1500 Expansion: Remove the AC power cord from the AC power port of the unit.
- Page 6 I/O M II R 1500 ODULE NSTALLATION UIDE UPER TACK EMOTE CCESS YSTEM Copyright © 1999, 3Com Corporation Part No. 1.024.1911 Rev 2.00...
Need help?
Do you have a question about the 3C421600A and is the answer not in the manual?
Questions and answers