Add Appletalk; Add Bridge; Access_ Mac_Address; Add Bridge Network - 3Com 3C421600A Reference Manual

58 C 4: R
HAPTER OUTER

add appletalk

add bridge

access_ mac_address

add bridge network

C R
OMMAND EFERENCE
network <network name>
zone
Defines an AppleTalk network and the zone(s) that are part of that
network.
Parameter
network <network
name>
zone <zone name>
<mac_address>
Adds to the list of devices which are allowed to access bridge network(s).
A bridge must have been previously defined, using add bridge
network, for this command to take effect. Using this list, you can limit
the access of a device to the bridge by not including the device MAC
address in this list. You must also enable bridge
access_mac_address for this bridge access limiting policy to take
effect. Check current access status by using show bridge settings.
Parameter
<mac_address>
enabled [no | yes]
interface <interface name>
user <username>
Defines a bridge network connection to allow your local area network
(LAN) users to bridge to LANs across the wide area network (WAN).
Bridging is supported over integrated services digital network (ISDN) and
Frame Relay. Note that routing takes precedence over bridging, so that
bridging does not occur unless you disable routing for the protocols you
wish to bridge. The protocols to bridge and other important parameters
are specified in the user you use to establish this connection. You must
use add user to create a network type user for this command and set
network user to specify the protocol and other parameters related to
bridging.
Description
Unique designation you assign for the AppleTalk network that
you want to configure. Limit: 32 ASCII characters. Maximum:
5 networks names.
Unique designation you assign for the AppleTalk zones that
you want to add. A zone name describes the logical network
segment on a physical network. The first zone on the list is the
"default zone." Limit: 32 ASCII characters. Maximum: 5 zone
names.
Description
MAC (Ethernet) address of workstation/host requiring bridge
access. Use arp command to verify the MAC address for IP,
list ipx routes for Internet Packet Exchange (IPX), or
list aarp for AppleTalk.