disable dns
host_rotation
disable icmp logging
disable icmp
router_advertise
disable interface
<interface name>
Remote — authentication based on a password stored in a RADIUS or
TACACS+ server.
Issue the show authentication command to display settings.
Use the show critical_event settings command to view
logging configuration and event sinks.
Disables the RAS 1500 process of randomly choosing a primary IP address
and up to eight alternates from the DNS cache.
Disables display of the Internet Control Message Protocol (ICMP) to the
SYSLOG server. Use the show icmp command to view edits.
Disables the RAS 1500-generated router advertisements multicast on the
same LAN segment as the RAS 1500. Use the show icmp command to
view edits.
Disables a specified interface. If a call is active on the interface, it is
disconnected. A disabled interface remains in the Interface Table, but
does not transmit or receive any data. Use the list interfaces
command to see the currently defined interfaces and their status.
You can disable multiple interfaces in one command. The following is the
list format:
disable interface <interface 1>,<interface 2>,...
The following is the format of each interface:
x/slot:y/mod:z
where x is the type of unit (rm0 for the RAS 1500 unit, pem0 or pem1 for
the RAS 1500 Port Expansion Unit, or pau0 for the RAS 1500 PAU), y is
the slot number, and z is the modem number.
Example:
rm0/slot:1/mod:1,pem0/slot:1/mod:2
Enter interfaces from the same slot in ranges.
Disable Commands
85