List Ip Interface_Block; List Ip Networks; List Ip Pools - 3Com 3C421600A Reference Manual

106 C 4: R
HAPTER OUTER

list ip interface_block

list ip networks

list ip pools

C R
OMMAND EFERENCE
Type — Ethernet interface type: Dynamic.
IfName — LAN interface name: rm0/eth:1.
Displays the IP addresses associated with each system interface. If the
interface has a point-to-point connection, the neighbor field contains the
address of the remote system. This command lists the following:
Address — IP address of the RAS 1500 interface.
Neighbor — IP address of the remote system.
Status — Status of the connection: Enabled or Disabled.
Interface — Any valid interface.
Displays all the IP networks you previously defined statically using the add
ip network command and any dynamic networks created with a
modem-established PPP/SLIP connection to the RAS 1500. It also lists the
following:
Name — Network designation.
Prot — IP protocol only.
Int — Name of the LAN interface this network runs on rm0/eth:1 (the
LAN interface), loopback, internal, or x/slot:y/mod:z (where x is the
type of unit (rm0 for the RAS 1500 unit: pem0 or pem1 for the RAS
1500 Expansion Unit), y is the slot number, and z is the modem
number; for example, rm0/slot:1/mod:1).
State — State of the network: Ena(bled) or Dis(abled).
Type — Static (user-specified), Auto (default) or Dynamic network.
Network address — Address of the IP network.
Displays the IP pools you configured with the add ip pool command. It
lists the following:
Name — Pool designation.
Address — Initial IP address and subnet mask of specified pool.
Size — Number of IP addresses you made available in the pool.
InUse — Number of IP addresses currently in use within the pool.
State — Conditional status of the IP pool: Public or private.