Internet Settings
IP Setup
3Com Corporation
The IP Setup Configuration described below is required for device management. IP
addresses can either be retrieved from a DHCP server or configured manually.
Figure 22 – IP Settings
If the Static IP radio button is selected, the static IP settings are displayed as
follow:
Figure 23 – Static IP Settings
IP Address – specify the bridge's IP address [digit and dots].
Subnet Mask – specify the bridge's subnet mask [digit and dots].
Default Gateway – specify the IP address of the bridge's gateway [digit and dots].
If you change the IP address manually, make sure that the chosen IP address is
free and belongs to the same IP subnet as the wired network; otherwise you will
lose the connection to the Wireless Bridge from your current PC. If you enable the
DHCP client via a Web browser, the browser will loose the connection after
rebooting, because the IP address assigned by the DHCP server is not
predictable.
The Wireless Bridge can be set as a DHCP server. Use DHCP configuration to
provide dynamic client IP Address from a range of IP Address.
Page 41