add frame_relay
pvc <pvc name>
dlci <dlci number>
interface
user <username>
add framed_route
user <name>
add init_script
<script_name>
verify filter command to check the filter syntax. You can view the
filters using the show filter command and verify that the filter is
correct by using the show file command.
Filter files are stored as ASCII files in FLASH memory.
Parameter
<filter_name>
Configures a user profile for a permanent virtual connection.
For example, the command,
add frame_relay pvc chicago dlci 16 interface rm/0/wan:1 user
tom
associates the profile of the username "tom," the data link connection
identifier "16," and the physical WAN port (interface) rm0/wan:1 to the
permanent virtual connection "chicago."
gateway [IP_address or name]
ip_route [IP_name or network_address]
{metric [number]}
Adds a framed (static) network to the user profile for dial-up connections.
This method of creating a static route does not run Routing Information
Protocol (RIP) to learn routes, so you must specify IP route and gateway
addresses. For comparison, see add ip route command.
Parameter
Description
<username>
Username specified for the framed network. Limit: 64 ASCII
characters.
gateway
IP address or name of the gateway used to reach this remote
network.
ip_route
IP name or address of the remote network.
metric
Integer representing how far away the route is, in "hops"
from other routers. Default: 1. Range: 1-15.
command <command_string>
Creates a modem initialization string, and adds it to the Init Script Table.
Use list init_scripts to view current Init script Table entries. After
you use the set switched interface command to assign an
Description
Designation of a filter file. Limit: 20 ASCII characters.
Add Commands
61