Facility Level Table; Module Table; Ip Network Table; Ip Address Pool Table - 3Com 3C421600A Reference Manual

26 C 1: R
HAPTER OUTER

Facility Level Table

Module Table

IP Network Table

IP Address Pool Table

IP Interface Block
Table
Forwarding and IP
Routing Tables
C O
ONFIGURATION VERVIEW
This table is used to configure the log level of all facilities (software
systems) on the RAS 1500. It contains each event facility and its
associated log level. Each facility generates unique event messages during
processing that can be sent to a SYSLOG server you define as a means of
judging system performance.
Facilities are configurable in that you can change log levels from the
defaults shown below. Available log levels are verbose, common,
unusual, and critical, with critical being the most severe event. This table
contains information accessed by the
This table contains information used by processes or management
features that run in the background. Display a list of these items using the
command.
list processes
The IP Network Table contains all generic protocol information about IP
networks entered with the
This table holds information on user-configured IP addresses entered with
the
add ip pool
This table contains IP addresses associated with each system interface.
Interfaces with point-to-point connections show the neighbor field with
the address of the remote system. Use the
display this table.
These tables contain static and dynamic routing information. Dynamic
routes are updated by broadcasts received from other routing devices on
the network using Routing Information Protocol (RIP). Static routes are
added to the table manually. A static route to a given site will override a
dynamic route.
Static routes to a given site are required when the site is not running
dynamic routing. Without dynamic routing protocol messaging, the RAS
1500 cannot gather information on the location of other routers,
gateways, and remote hosts. The RAS 1500 must know exactly where to
send a packet.
list facilities
add ip network
command.
command.
command.
list ip interface_block
to