Bye Command; Bye; Copy Command; Copy File <Input_File> <Output_File - 3Com 3C421600A Reference Manual

Bye Command

bye

Copy Command

copy file <input_file>
<output_file>

Delete Commands

delete address_pool
user <name>

delete appletalk

network
<network name>
delete appletalk
zone
<zone name>
delete bridge
access_mac_address
<mac_address>
delete bridge
network
<network name>
Exit the CLI, but keep this connection open. This command returns you to
the Dial-In User or Telnet commands.
Copies a file within the FLASH file system. This is a flat file system.
Delete commands remove anything you previously added.
pool_name <name>
Removes a user previously assigned to the specified address pool with the
add address_pool user command.
Deletes the AppleTalk network that you previously added using the add
appletalk network command. Make sure you disable the network
using disable appletalk network before deleting it. Use list
appletalk networks to view added networks.
Deletes an AppleTalk zone from an AppleTalk network. Make sure you
disable the network using disable appletalk network before
deleting the specified zone. Use list appletalk zones or show
appletalk network to verify the zone that is not in use.
Deletes a LAN user access to the bridge connection across the WAN. Use
list bridge access_mac_addresses to view which addresses are
available to delete.
Deletes the bridge network that you previously added using add
bridge network. Make sure you have disabled the bridge network,
using the disable bridge network command, before trying to
delete it. Use list bridge forwarding to see if there is any activity
over the bridge connection.
Bye Command 79